Electrodes for wood and building moisture measurement with the T2000

Different types of passive electrodes are used for determining the material or wood moisture and the humidity of mineral or porous building materials such as plaster or screed according to the resistance measuring method.

Below you will find all the electrodes in the T2000 programme. The minimum, maximum, average and “hold” values can be displayed with these electrodes in addition to the real time values when measuring with the T2000 (only T2000 S).


The application range of the electrodes is marked by a corresponding pictogram: Electrodes for measuring moisture content of buildings Electrodes for measuring moisture content of buildings
Electrodes for measuring moisture content of wood Electrodes for measuring moisture content of wood
TS 4/200 and TS 4/300 Round electrodes TS 4/200
and TS 4/300		   Building moisture
Very thin insertion electrodes (uninsulated, ø 2 mm) for moisture measurement in building and insulating materials through joints or cross joints.

Available in lengths 200 mm (TS 4/200)
and 300 mm (TS 4/300).

TS 12/200 and TS 12/300 Round electrodes TS 12/200
and TS 12/300		   Building moisture
Insulated electrodes (ø 4 mm) for specific moisture measurement in concealed component levels where the electrode shaft needs to be insulated. Absence of insulation would falsify the measuring result.
The most frequent use is the determination of moisture distribution of multilayered wall or ceiling structures such as floating screeds, multilayered walls, wooden beam ceilings, hot roofs etc.

Available in lengths 200 mm (TS 12/200)
and 300 mm (TS 12/300).

TS 20/110 TS 20/110 brush electrode   Building moisture
With 110 mm long brush head (ø 7 mm) and insulated shaft. The area of application is the specific measurement of moisture in a homogeneous building material without using a contact mass. The connection to the goods to be measured is made by the brush head.

TS 70 Ram electrode TS 70 Wood moisturemessung  
With moving hammer handle for precision zone and depth measurement especially in woods with different moisture distribution, e.g. liquid nests using Teflon-insulated electrode tips.

These are available in lengths of 45 and 60 mm

TS 8/200 and TS 8/300 Round electrodes TS 8/200
and TS 8/300 		Wood moisturemessung  
Uninsulated insertion electrodes (ø 4 mm) for measuring moisture on loose mounds such as wood wool or shavings.

Available in lengths 200 mm (TS 8/200)
and 300 mm (TS 8/300).

TS 16/200 and TS 16/300 Flat electrodes TS 16/200 and
TS 16/300		   Building moisture
The area of application corresponds to the area of application of the insulated round electrodes TS 12/200 and TS 12/300. The advantage of the flat electrodes (1 mm flat) is that there are no holes in the surface and the electrodes can be inserted through the edging strip after removing the base.

Available in the lengths 200 mm
(TS 16/200) and 300 mm (TS 16/300).

TS 60 Hand electrode TS 60 Wood moisturemessung Building moisture
Unbreakable plastic handle with two hexagon union nuts in which electrode tips of the following lengths can be inserted.

• 20 mm (max. penetration depth 14 mm)
• 30 mm (max. penetration depth 24 mm)
• 40 mm (max. penetration depth 34 mm)
• 60 mm (max. penetration depth 54 mm)

Areas of application are measurement of moisture in cut timber or wooden board materials (e.g. chipboard or fibre boards) and measurement of moisture in soft building materials such as plaster or roughcast mortar.